Generic filters

Suggested search terms: feesopenedge viewemvpci dssbatches

How can I test my Genius P400’s connection with the LAN and WAN?

You can test your Genius P400’s network connection using the Ethernet menu. The Ethernet menu allows you to view the network status and test your connection with both the Local Area Network (LAN) and the Wide Area Network (WAN), or with the internet using the ping function.

The Ethernet screen displays the current network status, which can be one of the following:

  • Down – If the Network is Down, your Genius P400 attempts to force a connection. If this attempt fails, your Genius P400 cannot connect to the LAN.
  • Up – If the Network is Up and the gateway ping fails, your Genius P400 can detect the LAN, but cannot establish connection to the WAN. This can be due to a firewall, a closed port, or your Genius P400 being configured for DHCP when a static configuration is required.

To test your Genius P400’s connection, complete the following steps:
Step 1. From the home screen, press 15, and 9 on the keypad at the same time.
Step 2. Use the keypad to type the password and then press Enter. The default password is 1166832.
Step 3. Navigate to the Ethernet menu and do the following:
a. Tap the Diagnostics tab.
b. Tap the Communication tab.
c. Tap the Ethernet tab.
Step 4. Tap Ping.
Step 5. To check connectivity with your LAN, enter an IP address from your network.
To check connectivity with the WAN, enter an IP address from outside your network.
Step 6. Tap OK. Ping test results display on the Ethernet screen.

Note: For addresses with octets with less than three digits, use leading zeros. For example, to use the address, enter

Step 7. In the upper-left corner of the display, tap Home.
Step 8. Tap Run App.

Was this post helpful?

Tags: , , , , , , , , ,